hard drive repair tools

When the hard disk "0" track is damaged, the system self-test passes, but the startup partition C drive directory is lost or missing, a regular hard disk, "creak ... creak ..." sound continues, if you run SCANDISK to scan C disk, In the first cluster a red "B" appears; Fdisk can not find the hard disk, partitioning software such as the use of a low version of the DM partitioning, the program gets "dead" in the track 0; if you "Format C:" it prompts 0 track damaged or read command "Track 0 Bad". Then the DM needs to be used to repair the hard drive.

First of all downloaded the DM from the Internet and producing a good DM and boot the floppy, then run DM and the main interface appears. In the main interface, press Alt + M key to enter the advanced mode of DM, point the cursor on the "(E) dit / View partitions" (Edit / View partition) option, press the Enter key, the program select the hard drive that needs repair, select the hard disk, press enter, then it enters the hard disk partition view interface.

In the partition list box, select "1" partition, then the partition information will appears above the partition information bar, such as the partition format, capacity, start cylinder, end of the cylinder and so on. At this point in the cylinder begins to remember the "0" and the end of the cylinder number "2489." Keep the cursor on the 1st partition, and then press the Del key to delete the partition, select "Yes" and enter, the 1st partition will be deleted.

Keep your cursor on the No. 1 partition, and then press the Ins key to create the partition, select "DOS-FAT32" option for the partition type, press Enter and go to the critical step - "Select Entry Mode" (reference your volume model). Also be sure to select "(C) ylinders" (stigma) option after entering the capacity of input interfaces. In the interface, you have to enter the data according to the cylinder capacity. For the first partition (i.e. C drive), both cylinder start from it, but now we need to change the "0" to "1", as the back end of the cylinder number of the partition does not need to amended.

After re-set the partition 1, return to the partition interface, point the cursor to the "Save and Continue" (save and continue) option to save the settings, then press the Esc key to exit DM, finally you are prompted to restart your computer.

Restart the computer; first reset the hard disk parameters in the BIOS under the through "IDE HDD Auto-Detection", and format drive C. At this point, the repair is finished.